Maintenance
Slings must be handled with the care that all equipment deserves. The use of edge protectors is always recommended, especially in areas where there is a higher risk of cuts or shearing, as the lifespan of the slings and workplace safety greatly depend on proper and careful use.
Safety in Use
-
Never overload the equipment. Do not use slings with an unidentified WLL (Working Load Limit).
-
Never use damaged slings.
-
Position the slings correctly. The load must be placed on the slings so that it is evenly distributed across their entire width.
-
Slings must never be knotted or twisted.
-
Slings must not be placed around sharp edges.
-
Do not allow slings to slide over corners or along edges.
-
Use protective edge guards on sharp corners.
-
Do not drag loads over the slings.
-
Arrange the slings correctly to allow for easy removal from the load after use.
-
Use well-rounded hooks.
-
Avoid placing more than one sling per hook.
-
When lifting heavy loads with more than one sling, remember that the total weight may not be evenly distributed.
-
Keep in mind that vibration during transport may cause friction. Use protective edge guards.
-
Do not use slings at temperatures above 100°C (212°F) or below -40°C (-40°F).
Inspection
The following procedure should be adopted by all users of our slings.
Remember: slings must be inspected at intervals no longer than two weeks when used for general lifting, and slings used for transport must be inspected before each trip.
-
Lay the slings flat on a horizontal surface in a well-lit area.
-
The entire length of the sling must be inspected.
-
The sling should be inspected by one person only.
